# This is BTBCM HAL overlay configuration file.

# Uart port name
UartPort = /dev/ttySAC18

# <boolean> Enable check whether let aoc controls power pin
AocPowerPinCtrlCheckEnable = true

# <string> The hardware stage does not need aoc to control power pin
# This only affects when AocPowerPinCtrlCheckEnable is true
HwStageDoesNotCtrlPowerPinFromAoc = PROTO1.0-EVT1.0-EVT1.2

# <string> The hardware stage with old chip revision is no longer
# supported by BT firmware.
HwStageWithOldChipFwNoLongerSupport = PROTO1.0-PROTO1.1

# Priority of uart type
# HciUartSocket = 0
# SerialUartPort = 1
# SerialAocUartPort = 2
# UserialInvalid = 3
UserialTypePriority = 2-1

# <string> The hardware support which offload capability
BtOffloadCap = AOC

# <string> The BT Offload Trunk Flag Group Name
BtOffloadTrunkGroup = 23P_AOC

# <boolean> APM Uart skip suspend to aovid hold system too long when BT using AOC UART
ApmUartSkipSuspend = true

# Sar backOff high resolution support
SarBackOffHighResolution = true

# Update BQR Event Mask property value
# TODO: remove this bqr event mask setting after Alpha exit
BqrEventMaskValueUpdate = 295006

BtA2dpOffloadCap = sbc-aac-aptx-aptxhd-ldac-opus

BtOpusEnabled = true